Suppr超能文献

颈动脉几何形状对壁面剪应力梯度大小及分布的影响。

Effect of carotid artery geometry on the magnitude and distribution of wall shear stress gradients.

作者信息

Wells D R, Archie J P, Kleinstreuer C

机构信息

Department of Mechanical and Aerospace Engineering, North Carolina State University, Raleigh, USA.

出版信息

J Vasc Surg. 1996 Apr;23(4):667-78. doi: 10.1016/s0741-5214(96)80048-6.

Abstract

PURPOSE

Recent information indicates that large, sustained wall shear stress gradients are a dominant hemodynamic parameter associated with the location and severity of atherosclerosis and myointimal hyperplasia. This study computes the spatial values of wall shear stresses and their gradients for three carotid artery bifurcation geometries.

METHODS

A computational fluid dynamics program was used to solve the transient two-dimensional partial differential equations that describe fluid flow. Blood was treated as both a Newtonian and a non-Newtonian incompressible fluid. Solutions for the velocities, wall shear stresses, and wall shear-stress gradients were obtained for three carotid bifurcation geometries: a normal carotid bifurcation (similar to a primarily reconstructed carotid endarterectomy), a patch-reconstructed carotid endarterectomy, and a gradually tapered, low-angle carotid bifurcation (no carotid bulb).

RESULTS

Computed velocity profiles closely match published experimental ones. Disturbed flow velocities are largest in the bulb segment of the normal carotid bifurcation. Peak and minimum wall shear stresses and peak shear stress gradients occurred in the lateral internal carotid artery wall. These were binodal in the normal or primarily reconstructed carotid artery, localized at the distal end of the patch-reconstructed carotid bifurcation, and minimal in the smooth, tapered carotid bifurcation. Wall shear stresses and their gradients were slightly higher for non-Newtonian than Newtonian fluids in the normal carotid artery but were similar in the other two geometric configurations.

CONCLUSION

These results indicate that flow disturbances in general and wall shear stress gradients in particular are markedly reduced in carotid artery bifurcations that are smooth and gradually tapered and do not have a bulb. Abrupt geometric wall changes such as those occurring in the normal carotid bulb and at the distal end of a patch-reconstruction after carotid endarterectomy are harbingers of disturbed flow and high wall shear stress gradients. These results suggest that carotid endarterectomy reconstruction geometry characterized by a gradually tapered internal carotid artery may minimize the hemodynamically induced component of early myointimal hyperplasia and thrombosis and late atherosclerotic restenosis.

摘要

目的

近期信息表明,大的、持续的壁面剪应力梯度是与动脉粥样硬化和肌内膜增生的位置及严重程度相关的主要血流动力学参数。本研究计算了三种颈动脉分叉几何形状的壁面剪应力及其梯度的空间值。

方法

使用计算流体动力学程序求解描述流体流动的瞬态二维偏微分方程。血液被视为牛顿流体和非牛顿不可压缩流体。获得了三种颈动脉分叉几何形状的速度、壁面剪应力和壁面剪应力梯度的解:正常颈动脉分叉(类似于初次重建的颈动脉内膜切除术)、补片重建的颈动脉内膜切除术以及逐渐变细、低角度的颈动脉分叉(无颈动脉球)。

结果

计算得到的速度剖面与已发表的实验结果密切匹配。正常颈动脉分叉的球部段血流紊乱速度最大。峰值和最小壁面剪应力以及峰值剪应力梯度出现在颈内动脉外侧壁。在正常或初次重建的颈动脉中这些是双峰的,位于补片重建的颈动脉分叉远端,在平滑、逐渐变细的颈动脉分叉中最小。在正常颈动脉中,非牛顿流体的壁面剪应力及其梯度略高于牛顿流体,但在其他两种几何构型中相似。

结论

这些结果表明,在平滑、逐渐变细且无球部的颈动脉分叉中,一般的血流紊乱尤其是壁面剪应力梯度明显降低。正常颈动脉球以及颈动脉内膜切除术后补片重建远端出现的几何壁面突然变化是血流紊乱和高壁面剪应力梯度的先兆。这些结果表明,以颈内动脉逐渐变细为特征的颈动脉内膜切除术重建几何形状可能会使早期肌内膜增生和血栓形成以及晚期动脉粥样硬化再狭窄的血流动力学诱导成分最小化。

文献检索

告别复杂PubMed语法,用中文像聊天一样搜索,搜遍4000万医学文献。AI智能推荐,让科研检索更轻松。

立即免费搜索

文件翻译

保留排版,准确专业,支持PDF/Word/PPT等文件格式,支持 12+语言互译。

免费翻译文档

深度研究

AI帮你快速写综述,25分钟生成高质量综述,智能提取关键信息,辅助科研写作。

立即免费体验