Sabty-Daily Rania A, Harris Patricia A, Hinds William C, Froines John R
Health Science Program, 5151 State University Drive, California State University,Los Angeles, CA 90032-8171, USA.
Ann Occup Hyg. 2005 Jan;49(1):47-59. doi: 10.1093/annhyg/meh081. Epub 2004 Dec 10.
Spray painters are potentially exposed to aerosol containing Cr(VI) via inhalation of chromate-based paint spray. Two field studies were conducted at an aerospace facility to determine the size distribution and speciation of Cr(VI) in paint spray aerosol. Sampled paint products consisted of sparingly soluble strontium chromate in an epoxy resin matrix, a matrix generally known for its durability and toughness. Personal aerosol samples were collected using Sierra Marple personal cascade impactors and analyzed for Cr(VI) and total Cr. The size distribution of total Cr particles in the paint aerosol had a Mass Median Aerodynamic Diameter (MMAD) of 7.5 mum [Geometric Standard Deviation (GSD = 2.7 mum)] in both field studies. The MMAD of Cr(VI) particles was 8.5 mum (GSD = 2.2 mum). Particles >2 mum constituted 90% or more of the total Cr and the Cr(VI) mass, in all sampled paint aerosols and were lognormally distributed. The target site for respiratory deposition of Cr in the aerosol was estimated based on the mass distribution of Cr according to particle size. On an average, 62% of the Cr and Cr(VI) mass in the paint aerosol consisted of particles >10 mum. This study showed that 71.8% of Cr(VI) mass in paint spray aerosol potentially inhaled by a spray painter may deposit in the head airways region. Only 2.0 and 1.4% of Cr(VI) mass in the paint aerosol may potentially deposit in the alveolar and tracheobronchial region, respectively. The ratio of Cr(VI) mass to total Cr mass was determined in bulk paint and the data indicate that Cr was predominantly in the Cr(VI) valence state, before spraying. The ratio of Cr(VI) mass to total Cr mass was also determined in paint aerosol samples. The data indicated that there was a reduction of Cr(VI) regardless of Cr aerosol particle size. Cr(VI) reduction occurred most likely during the 8 h sample collection time period. These findings are in agreement with the findings that observed Cr(VI) reduction during collection of airborne Cr(VI) in samples of chromic acid mist. The use of Cr(VI) stabilizing sampling media and the storage of samples at lower temperatures (4 degrees C ) during and after sampling may avoid the underestimation of Cr(VI).
喷漆工人可能通过吸入铬酸盐基喷漆而接触到含有六价铬(Cr(VI))的气溶胶。在一家航空航天设施进行了两项现场研究,以确定喷漆气溶胶中六价铬的粒径分布和形态。所采样的油漆产品是在环氧树脂基质中含有微溶性铬酸锶,该基质通常以其耐久性和韧性而闻名。使用Sierra Marple个人级联冲击器收集个人气溶胶样本,并分析其中的六价铬和总铬含量。在两项现场研究中,油漆气溶胶中总铬颗粒的粒径分布的质量中位空气动力学直径(MMAD)为7.5微米[几何标准差(GSD = 2.7微米)]。六价铬颗粒的MMAD为8.5微米(GSD = 2.2微米)。在所有采样的油漆气溶胶中,粒径大于2微米的颗粒占总铬和六价铬质量的90%或更多,且呈对数正态分布。根据粒径对气溶胶中铬的呼吸道沉积目标部位进行了估计。平均而言,油漆气溶胶中62%的铬和六价铬质量由粒径大于10微米的颗粒组成。该研究表明,喷漆工人可能吸入的喷漆气溶胶中71.8%的六价铬质量可能沉积在头部气道区域。油漆气溶胶中六价铬质量分别只有2.0%和1.4%可能沉积在肺泡和气管支气管区域。在散装油漆中测定了六价铬质量与总铬质量的比率,数据表明在喷漆前铬主要处于六价态。还在油漆气溶胶样本中测定了六价铬质量与总铬质量的比率。数据表明,无论铬气溶胶粒径大小,六价铬都有减少。六价铬的减少最有可能发生在8小时的样本采集时间段内。这些发现与在铬酸雾样本中采集空气中六价铬期间观察到六价铬减少的发现一致。使用六价铬稳定采样介质以及在采样期间和采样后将样本储存在较低温度(4摄氏度)下可能避免对六价铬的低估。