Lim Chang-Uk, Zhang Ying, Fox Michael H
Cell and Molecular Biology Graduate Program, Colorado State University, Fort Collins, CO 80523, USA.
Int J Hyperthermia. 2006 Feb;22(1):77-91. doi: 10.1080/02656730500430538.
The effects of heat are strongly dependent on the time of heating at a given temperature. The relationship between treatment time and temperature for a biological isoeffect (the Arrhenius plot) has been confirmed for a variety of normal tissues and tumours. A marked change of slope occurs somewhere between 42-43 degrees C. Above this transition temperature the slope is constant for a variety of cells and tissues. Therefore, when defining thermal doses in hyperthermia studies, both the time and temperature of heating are equally important determinants. In this study, cell cycle progression and apoptosis were analysed in HL-60 cells after heating from 5-60 min at 45.0 degrees C and also heating with five different iso-dose time-temperature heat treatments. A heat shock of 5-15 min at 45.0 degrees C caused the accumulation of cells in G1 and G2/M phases after 12 h at 37 degrees C, whereas a heat shock of 20-60 min at 45.0 degrees C reduced the number of non-apoptotic cells in all phases because the number of apoptotic cells increased. The fraction of apoptotic cells followed a sigmoid curve as the heating time increased from 5-60 min at 45.0 degrees C. Cell cycle analysis showed that apoptosis occurred predominantly in S-phase cells for shorter heating times but in all phases at longer times. An isodose heat shock lower than 44.0 degrees C (42.0-43.0 degrees C) gave the same apoptotic index, while heat shock from 44.0-46.0 degrees C caused a greater than expected apoptotic index. Thus, there was a transition at 44.0 degrees C in HL-60 cells, above which apoptosis increased rapidly. These results indicate that isodose analysis based on clonogenic survival in fibroblast cells may not be relevant for cell types which readily undergo apoptosis. Clonogenic survival was also compared with apoptosis for HL-60 cells and an apoptotic-resistant derivative cell line, HWC-2, heated for various times at 45.0 degrees C. Survival based on a clonogenic assay was much lower than survival based only on apoptotic index at all times for HL-60 cells. HWC-2 cells did not undergo apoptosis and also had a higher clonogenic survival than HL-60 cells.
热效应在很大程度上取决于在给定温度下的加热时间。对于多种正常组织和肿瘤,已证实了生物等效应(阿累尼乌斯曲线)的治疗时间与温度之间的关系。在42 - 43摄氏度之间的某个温度处,斜率会发生明显变化。高于这个转变温度后,对于多种细胞和组织,斜率是恒定的。因此,在热疗研究中定义热剂量时,加热时间和温度都是同样重要的决定因素。在本研究中,对HL - 60细胞在45.0摄氏度下加热5 - 60分钟后以及用五种不同的等剂量时间 - 温度热疗进行加热后的细胞周期进程和凋亡情况进行了分析。在45.0摄氏度下热休克5 - 15分钟会导致细胞在37摄氏度下培养12小时后在G1期和G2/M期积累,而在45.0摄氏度下热休克20 - 60分钟会减少所有阶段非凋亡细胞的数量,因为凋亡细胞的数量增加了。当在45.0摄氏度下加热时间从5 - 60分钟增加时,凋亡细胞的比例呈S形曲线。细胞周期分析表明,在较短加热时间时,凋亡主要发生在S期细胞中,但在较长时间时则发生在所有阶段。低于44.0摄氏度(42.0 - 43.0摄氏度)的等剂量热休克产生相同的凋亡指数,而44.0 - 46.0摄氏度的热休克导致的凋亡指数高于预期。因此,HL - 60细胞在44.0摄氏度处存在转变,高于此温度凋亡迅速增加。这些结果表明,基于成纤维细胞克隆存活的等剂量分析可能不适用于容易发生凋亡的细胞类型。还比较了HL - 60细胞和抗凋亡衍生细胞系HWC - 2在45.0摄氏度下加热不同时间后的克隆存活与凋亡情况。对于HL - 60细胞,在所有时间点,基于克隆测定的存活率远低于仅基于凋亡指数的存活率。HWC - 2细胞不发生凋亡,并且其克隆存活率也高于HL - 60细胞。