Department of Biomedical Engineering, Northwestern University, Evanston, USA.
Biomech Model Mechanobiol. 2010 Feb;9(1):19-33. doi: 10.1007/s10237-009-0156-3. Epub 2009 Apr 23.
Schlemm's canal (SC) endothelial cells are likely important in the physiology and pathophysiology of the aqueous drainage system of the eye, particularly in glaucoma. The mechanical stiffness of these cells determines, in part, the extent to which they can support a pressure gradient and thus can be used to place limits on the flow resistance that this layer can generate in the eye. However, little is known about the biomechanical properties of SC endothelial cells. Our goal in this study was to estimate the effective Young's modulus of elasticity of normal SC cells. To do so, we combined magnetic pulling cytometry of isolated cultured human SC cells with finite element modeling of the mechanical response of the cell to traction forces applied by adherent beads. Preliminary work showed that the immersion angles of beads attached to the SC cells had a major influence on bead response; therefore, we also measured bead immersion angle by confocal microscopy, using an empirical technique to correct for axial distortion of the confocal images. Our results showed that the upper bound for the effective Young's modulus of elasticity of the cultured SC cells examined in this study, in central, non-nuclear regions, ranged between 1,007 and 3,053 Pa, which is similar to, although somewhat larger than values that have been measured for other endothelial cell types. We compared these values to estimates of the modulus of primate SC cells in vivo, based on images of these cells under pressure loading, and found good agreement at low intraocular pressure (8-15 mm Hg). However, increasing intraocular pressure (22-30 mm Hg) appeared to cause a significant increase in the modulus of these cells. These moduli can be used to estimate the extent to which SC cells deform in response to the pressure drop across the inner wall endothelium and thereby estimate the extent to which they can generate outflow resistance.
许旺氏管(SC)内皮细胞在眼睛房水引流系统的生理学和病理生理学中可能很重要,尤其是在青光眼。这些细胞的机械硬度决定了它们在多大程度上能够支持压力梯度,因此可以用来限制这一层在眼睛中产生的流动阻力。然而,关于 SC 内皮细胞的生物力学特性知之甚少。我们在这项研究中的目标是估计正常 SC 细胞的有效杨氏弹性模量。为此,我们将分离培养的人 SC 细胞的磁拉细胞术与细胞对附着珠施加的牵引力的机械响应的有限元模型相结合。初步研究表明,附着在 SC 细胞上的珠的浸入角度对珠的响应有很大影响;因此,我们还通过共聚焦显微镜测量了珠的浸入角度,使用经验技术校正共聚焦图像的轴向失真。我们的结果表明,在本研究中检查的培养的 SC 细胞的有效杨氏弹性模量的上限,在中央、非核区域,范围在 1007 到 3053Pa 之间,与已经测量到的其他内皮细胞类型的值相似,尽管略大一些。我们将这些值与基于这些细胞在压力加载下的图像对体内灵长类 SC 细胞的模量的估计进行了比较,并在低眼内压(8-15mmHg)下发现了很好的一致性。然而,眼内压升高(22-30mmHg)似乎会导致这些细胞的模量显著增加。这些模量可用于估计 SC 细胞在响应内壁内皮细胞跨壁压降时的变形程度,从而估计它们产生流出阻力的程度。