Department of Physics, Arizona State University, Tempe, AZ 85287, USA.
Phys Biol. 2011 Feb;8(1):015007. doi: 10.1088/1478-3975/8/1/015007. Epub 2011 Feb 7.
The mechanical stiffness of individual cells is important in tissue homeostasis, cell growth, division and motility, and the epithelial-mesenchymal transition in the initiation of cancer. In this work, a normal squamous cell line (EPC2) and metaplastic (CP-A) as well as dysplastic (CP-D) Barrett's Esophagus columnar cell lines are studied as a model of pre-neoplastic progression in the human esophagus. We used the combination of an atomic force microscope (AFM) with a scanning confocal fluorescence lifetime imaging microscope to study the mechanical properties of single adherent cells. Sixty four force indentation curves were taken over the nucleus of each cell in an 8 x 8 grid pattern. Analyzing the force indentation curves, indentation depth-dependent Young's moduli were found for all cell lines. Stiffness tomograms demonstrate distinct differences between the mechanical properties of the studied cell lines. Comparing the stiffness for indentation forces of 1 nN, most probable Young's moduli were calculated to 4.7 kPa for EPC2 (n = 18 cells), 3.1 kPa for CP-A (n = 10) and 2.6 kPa for CP-D (n = 19). We also tested the influence of nuclei and nucleoli staining organic dyes on the mechanical properties of the cells. For stained EPC2 cells (n = 5), significant stiffening was found (9.9 kPa), while CP-A cells (n = 5) showed no clear trend (2.9 kPa) and a slight softening was observed (2.1 kPa) in the case of CP-D cells (n = 16). Some force-indentation curves show non-monotonic discontinuities with segments of negative slope, resembling a sawtooth pattern. We found the incidence of these 'breakthrough events' to be highest in the dysplastic CP-D cells, intermediate in the metaplastic CP-A cells and lowest in the normal EPC2 cells. This observation suggests that the microscopic explanation for the increased compliance of cancerous and pre-cancerous cells may lie in their susceptibility to 'crumble and yield' rather than their ability to 'bend and flex'.
单个细胞的机械硬度在组织稳态、细胞生长、分裂和迁移以及上皮-间充质转化(癌症起始的关键过程)中起着重要作用。在这项工作中,我们以人食管的癌前病变进展模型,研究了正常鳞状细胞系(EPC2)和化生(CP-A)以及发育不良(CP-D)巴雷特食管柱状细胞系。我们使用原子力显微镜(AFM)与扫描共聚焦荧光寿命成像显微镜相结合,研究了单个贴壁细胞的机械性能。在 8 x 8 网格图案中,对每个细胞核进行了 64 次力压痕曲线测量。分析力压痕曲线,发现所有细胞系的压痕深度相关杨氏模量。刚度断层扫描图显示了研究细胞系之间机械性能的明显差异。比较 1 nN 压痕力的刚度,计算出 EPC2(n = 18 个细胞)的最可能杨氏模量为 4.7 kPa,CP-A(n = 10)为 3.1 kPa,CP-D(n = 19)为 2.6 kPa。我们还测试了核和核仁染色有机染料对细胞机械性能的影响。对于染色的 EPC2 细胞(n = 5),发现明显的硬度增加(9.9 kPa),而 CP-A 细胞(n = 5)没有明显的趋势(2.9 kPa),CP-D 细胞(n = 16)观察到轻微软化(2.1 kPa)。一些力压痕曲线显示出非单调不连续,具有负斜率的段,类似于锯齿图案。我们发现,这些“突破事件”的发生率在发育不良的 CP-D 细胞中最高,在化生的 CP-A 细胞中中等,在正常的 EPC2 细胞中最低。这一观察结果表明,癌症和癌前细胞顺应性增加的微观解释可能在于它们易于“崩溃和屈服”,而不是它们“弯曲和灵活”的能力。