Kegel Jan, Laffir Fathima, Povey Ian M, Pemble Martyn E
Tyndall National Institute, University College Cork, Lee Maltings, Cork, Ireland.
Phys Chem Chem Phys. 2017 May 17;19(19):12255-12268. doi: 10.1039/c7cp01606a.
Intentionally defect-rich zinc oxide (ZnO) nanorod-arrays were grown from solution by carefully adjusting the concentration ratio of the growth-precursors used followed by various post-deposition thermal treatments. Post-deposition rapid thermal annealing (RTA) at moderate temperatures (350 °C-550 °C) and in various atmospheres was applied to vary the defect composition of the grown nanorod-arrays. It is demonstrated that, intense, defect-related orange emission occurs solely upon RTA around 450 °C and is essentially independent of the atmosphere used. Extensive materials characterization was carried out in order to evaluate the origin of the orange-luminescent defects and what influence they have on the ZnO material properties. It is concluded that the oxygen vacancy-zinc interstitial defect complex (V-Zn) is responsible for the orange luminescence in the prepared materials. A kinetic formation mechanism of the V-Zn complex dependent on the RTA temperature is proposed and shown to be in accordance with the experimental findings. Furthermore it is shown that this bulk deep-level defect could act as a trap state for photo-generated electrons prolonging the charge carrier lifetime of photo-generated holes and therefore improving the charge carrier separation in the material. As a result the photo-current density under simulated sunlight is found to increase by almost 150% over as-grown samples. The potential use of this defective material in applications such as solar water splitting is outlined.
通过仔细调整生长前驱体的浓度比,随后进行各种沉积后热处理,从溶液中生长出有意富含缺陷的氧化锌(ZnO)纳米棒阵列。在中等温度(350℃ - 550℃)下于各种气氛中进行沉积后快速热退火(RTA),以改变生长的纳米棒阵列的缺陷组成。结果表明,仅在约450℃的RTA处理时会出现强烈的、与缺陷相关的橙色发射,且基本上与所用气氛无关。为了评估橙色发光缺陷的起源及其对ZnO材料性能的影响,进行了广泛的材料表征。得出的结论是,氧空位 - 锌间隙缺陷复合体(V - Zn)是所制备材料中橙色发光的原因。提出了一种依赖于RTA温度的V - Zn复合体的动力学形成机制,并表明其与实验结果一致。此外,还表明这种体深能级缺陷可以作为光生电子的陷阱态,延长光生空穴的载流子寿命,从而改善材料中的载流子分离。结果发现,在模拟阳光下,这种缺陷材料的光电流密度比生长态样品增加了近150%。概述了这种缺陷材料在太阳能水分解等应用中的潜在用途。