Schwarz Timo Julian, Weber Markus, Dornia Christian, Worlicek Michael, Renkawitz Tobias, Grifka Joachim, Craiovan Benjamin
Department of Orthopedic Surgery, University Medical Center Regensburg, Bad Abbach, Germany.
Department of Radiology, University Medical Center, Regensburg.
Rofo. 2017 Sep;189(9):864-873. doi: 10.1055/s-0043-110012. Epub 2017 Jul 11.
Accurate assessment of cup orientation on postoperative pelvic radiographs is essential for evaluating outcome after THA. Here, we present a novel method for correcting measurement inaccuracies due to pelvic tilt and rotation. In an experimental setting, a cup was implanted into a dummy pelvis, and its final position was verified via CT. To show the effect of pelvic tilt and rotation on cup position, the dummy was fixed to a rack to achieve a tilt between + 15° anterior and -15° posterior and 0° to 20° rotation to the contralateral side. According to Murray's definitions of anteversion and inclination, we created a novel corrective procedure to measure cup position in the pelvic reference frame (anterior pelvic plane) to compensate measurement errors due to pelvic tilt and rotation. The cup anteversion measured on CT was 23.3°; on AP pelvic radiographs, however, variations in pelvic tilt (± 15°) resulted in anteversion angles between 11.0° and 36.2° (mean error 8.3°± 3.9°). The cup inclination was 34.1° on CT and ranged between 31.0° and 38.7° (m. e. 2.3°± 1.5°) on radiographs. Pelvic rotation between 0° and 20° showed high variation in radiographic anteversion (21.2°-31.2°, m. e. 6.0°± 3.1°) and inclination (34.1°-27.2°, m. e. 3.4°± 2.5°). Our novel correction algorithm for pelvic tilt reduced the mean error in anteversion measurements to 0.6°± 0.2° and in inclination measurements to 0.7° (SD± 0.2). Similarly, the mean error due to pelvic rotation was reduced to 0.4°± 0.4° for anteversion and to 1.3°± 0.8 for inclination. Pelvic tilt and pelvic rotation may lead to misinterpretation of cup position on anteroposterior pelvic radiographs. Mathematical correction concepts have the potential to significantly reduce these errors, and could be implemented in future radiological software tools. · Pelvic tilt and rotation influence cup orientation after THA. · Cup anteversion and inclination should be referenced to the pelvis. · Radiological measurement errors of cup position may be reduced by mathematical concepts. · Schwarz TJ, Weber M, Dornia C et al. Correction of Pelvic Tilt and Pelvic Rotation in Cup Measurement after THA - An Experimental Study. Fortschr Röntgenstr 2017; 189: 864 - 873.
准确评估术后骨盆X线片上髋臼的方向对于评估全髋关节置换术(THA)后的效果至关重要。在此,我们提出一种新方法,用于纠正由于骨盆倾斜和旋转导致的测量不准确。在实验环境中,将一个髋臼杯植入模拟骨盆中,并通过CT验证其最终位置。为了显示骨盆倾斜和旋转对髋臼杯位置的影响,将模拟骨盆固定在一个架子上,以实现+15°前倾角至 -15°后倾角以及向对侧0°至20°的旋转。根据默里对前倾角和倾斜角的定义,我们创建了一种新的校正程序,以在骨盆参考框架(骨盆前平面)中测量髋臼杯位置,以补偿由于骨盆倾斜和旋转导致的测量误差。CT测量的髋臼杯前倾角为23.3°;然而,在前后位骨盆X线片上,骨盆倾斜(±15°)的变化导致前倾角在11.0°至36.2°之间(平均误差8.3°±3.9°)。CT测量的髋臼杯倾斜角为34.1°,X线片上的范围在31.0°至38.7°之间(平均误差2.3°±1.5°)。0°至20°的骨盆旋转显示出X线片上前倾角(21.2° - 31.2°,平均误差6.0°±3.1°)和倾斜角(34.1° - 27.2°,平均误差3.4°±2.5°)的高度变化。我们针对骨盆倾斜的新校正算法将前倾角测量的平均误差降低至0.6°±0.2°,倾斜角测量的平均误差降低至0.7°(标准差±0.2)。同样,由于骨盆旋转导致的前倾角平均误差降低至0.4°±0.4°,倾斜角平均误差降低至1.3°±0.8°。骨盆倾斜和骨盆旋转可能导致对前后位骨盆X线片上髋臼杯位置的错误解读。数学校正概念有可能显著减少这些误差,并可在未来的放射学软件工具中实现。·骨盆倾斜和旋转会影响全髋关节置换术后髋臼杯的方向。·髋臼杯的前倾角和倾斜角应以骨盆为参考。·髋臼杯位置的放射学测量误差可通过数学概念降低。·施瓦茨TJ,韦伯M,多尔尼亚C等。全髋关节置换术后髋臼杯测量中骨盆倾斜和骨盆旋转的校正 - 一项实验研究。《Fortschr Röntgenstr》2017年;189: 864 - 873。