Burch G E
Eur J Cardiol. 1978 Sep;8(2):207-36.
Precordial leads were first used by Waller, whose capillary electroscope was too insensitive to detect the electric forces emanating from the human heart unless the electrode was placed over the precordium as near to the heart as possible. When Einthoven developed the elegant, reliable and sensitive string galvanometer, he could record the electric forces of the heart from the hands and feet of the subject without even undressing him. When Einthoven's great galvanometer became available, only the three standard limb leads were used. Thomas Lewis and others experimented with precordial direct leads and made many important discoveries in electrocardiography and cardiology. Wolferth and Wood, in 1932, introduced the first precordial lead in clinical, diagnostic cardiology. The recordings were 'upside-down', i.e. positive deflections were down and negative ones up. They called this the 4th lead (lead IV). The precordial electrode was placed on the chest over the apex of the heart, regardless of where the apex was located. This immediately opened new avenues of study in infarction, ventricular hypertrophy, bundle branch block, and all other cardiac states. Then CL, CR, CF, CB and V leads were introduced. The points considered best for placing the 'exploring' or precordial electrode became an issue, and much confusion prevailed until Wilson and his associates developed the central or isopotential terminal and until the American Heart Association and the Heart Society of Britain and Ireland met in London and published the standards for recording precordial leads in 1938. There followed, for obvious reasons, a slow settling of the confusion until the V1 through V6 precordial leads became standard procedure all over the world, as exists today. Goldberger introduced the augmented unipolar limb leads (aVR, aVL and aVF) which have resulted in the standard 12-lead electrocardiogram of routine use today. No one would consider an electrocardiographic evaluation adequate in a cardiac study at present unless the 12-lead ECG were recorded.
胸前导联最初由沃勒使用,他的毛细管静电计过于不灵敏,无法检测到发自人体心脏的电力,除非将电极尽可能靠近心脏地放置在胸前区。当艾因托芬研制出精美、可靠且灵敏的弦线电流计时,他甚至无需让受试者脱衣,就能从其双手和双脚记录心脏的电力。当艾因托芬的大型电流计问世后,最初仅使用三条标准肢体导联。托马斯·刘易斯等人对胸前直接导联进行了实验,并在心电图学和心脏病学领域取得了许多重要发现。1932年,沃尔费思和伍德在临床诊断心脏病学中引入了首个胸前导联。记录结果是“颠倒的”,即正向波向下,负向波向上。他们将此称为第4导联(导联IV)。胸前电极放置在心脏心尖上方的胸部,而不论心尖位于何处。这立即为心肌梗死、心室肥大、束支传导阻滞以及所有其他心脏状况的研究开辟了新途径。随后引入了CL、CR、CF、CB和V导联。对于放置“探测”或胸前电极的最佳位置成为了一个问题,在威尔逊及其同事研制出中心或等电位端之前,一直存在诸多混乱,直到美国心脏协会以及英国和爱尔兰心脏学会在伦敦会面并于1938年发布了胸前导联记录标准。由于显而易见的原因,混乱状况经过缓慢的梳理,直到V1至V6胸前导联成为如今全球通用的标准操作流程。戈德伯格引入了加压单极肢体导联(aVR、aVL和aVF),这才有了如今常规使用的标准12导联心电图。目前,在心脏研究中,除非记录12导联心电图,否则没有人会认为心电图评估是充分的。