Tower Semiconductors, Migdal HaEmek 2310502, Israel.
Sensors (Basel). 2023 Feb 24;23(5):2509. doi: 10.3390/s23052509.
We report on novel UVC sensors based on the floating gate (FG) discharge principle. The device operation is similar to that of EPROM non-volatile memories UV erasure, but the sensitivity to ultraviolet light is strongly increased by using single polysilicon devices of special design with low FG capacitance and long gate periphery (grilled cells). The devices were integrated without additional masks into a standard CMOS process flow featuring a UV-transparent back end. Low-cost integrated UVC solar blind sensors were optimized for implementation in UVC sterilization systems, where they provided feedback on the radiation dose sufficient for disinfection. Doses of ~10 µJ/cm at 220 nm could be measured in less than a second. The device can be reprogrammed up to 10,000 times and used to control ~10-50 mJ/cm UVC radiation doses typically employed for surface or air disinfection. Demonstrators of integrated solutions comprising UV sources, sensors, logics, and communication means were fabricated. Compared with the existing silicon-based UVC sensing devices, no degradation effects that limit the targeted applications were observed. Other applications of the developed sensors, such as UVC imaging, are also discussed.
我们报告了基于浮栅(FG)放电原理的新型 UVC 传感器。该器件的工作原理类似于 EPROM 非易失性存储器的 UV 擦除,但通过使用具有低 FG 电容和长栅极周长(栅格单元)的特殊设计的单多晶硅器件,对紫外线的灵敏度得到了极大提高。这些器件无需额外掩模即可集成到具有 UV 透明后端的标准 CMOS 工艺流程中。低成本集成式 UVC 日盲传感器经过优化,可用于 UVC 杀菌系统中,为消毒所需的辐射剂量提供反馈。在 220nm 处,可在不到一秒的时间内测量到约 10µJ/cm 的剂量。该器件可重复编程多达 10000 次,并用于控制通常用于表面或空气消毒的约 10-50mJ/cm 的 UVC 辐射剂量。包括 UV 源、传感器、逻辑和通信手段的集成解决方案演示器已被制造出来。与现有的基于硅的 UVC 感应器件相比,没有观察到限制目标应用的退化效应。还讨论了开发的传感器的其他应用,例如 UVC 成像。