Giddens D P, Zarins C K, Glagov S
Whiting School of Engineering, Johns Hopkins University, Baltimore, MD 21218.
J Biomech Eng. 1993 Nov;115(4B):588-94. doi: 10.1115/1.2895545.
Fluid dynamics research over the past twenty years has contributed immensely to our knowledge of atherosclerosis. The ability to detect localized atherosclerotic plaques using noninvasive ultrasonic methods was advanced significantly by investigations into the nature and occurrence of velocity disturbances created by arterial stenoses, and diagnosis of carotid bifurcation disease using a combination of ultrasonic imaging and Doppler measurement of blood velocity is now quite routine. Since atherosclerotic plaques tend to be localized at sites of branching and artery curvature and since these locations would be expected to harbor complex flow patterns, investigators postulated that fluid dynamics might play an initiating role in atherogenesis. Several fluid dynamic variables were proposed as initiating factors. Investigations were undertaken during the 1980s in which fluid dynamic model experiments with physiologic geometries and flow conditions were employed to simulate arterial flows and in which morphometric mapping of intimal thickness was performed in human arteries. Correlations between fluid dynamic variables and intimal thickness revealed that atherosclerotic plaques tended to occur at sites of low and oscillating wall shear stress; and these observations were reinforced by studies in a monkey model of atherosclerosis. Concomitantly, it was realized that arteries adapt their diameters so as to maintain wall shear stress in a narrow range of values around 15 dynes/cm2, findings which were based both on observations of normal arteries and on animal studies in which flow rates were manipulated and arterial diameter adaptation was measured.(ABSTRACT TRUNCATED AT 250 WORDS)
在过去二十年中,流体动力学研究极大地增进了我们对动脉粥样硬化的了解。通过对动脉狭窄所产生的速度紊乱的性质和发生情况进行研究,使用非侵入性超声方法检测局部动脉粥样硬化斑块的能力得到了显著提升,如今,结合超声成像和血流速度多普勒测量来诊断颈动脉分叉疾病已相当常规。由于动脉粥样硬化斑块往往位于分支和动脉弯曲部位,且预计这些位置存在复杂的血流模式,研究人员推测流体动力学可能在动脉粥样硬化的发生中起起始作用。提出了几个流体动力学变量作为起始因素。在20世纪80年代进行了多项研究,采用具有生理几何形状和流动条件的流体动力学模型实验来模拟动脉血流,并对人体动脉进行内膜厚度的形态测量。流体动力学变量与内膜厚度之间的相关性表明,动脉粥样硬化斑块往往出现在低壁面剪切应力和振荡壁面剪切应力的部位;这些观察结果在动脉粥样硬化猴子模型的研究中得到了加强。与此同时,人们认识到动脉会调整其直径,以便将壁面剪切应力维持在15达因/平方厘米左右的狭窄范围内,这一发现基于对正常动脉的观察以及对流速进行操控并测量动脉直径适应性的动物研究。(摘要截取自250词)