Suppr超能文献

铸造工人死亡率研究。

A mortality study of foundry workers.

作者信息

Koskela R S, Hernberg S, Kärävä R, Järvinen E, Nurminen M

出版信息

Scand J Work Environ Health. 1976;2 Suppl 1:73-89. doi: 10.5271/sjweh.2829.

Abstract

The mortality of foundry workers was studied from a sample of all those men employed in 20 representative iron, steel, and nonferrous foundries for any period of time during 1950 through 1972. A statistical sample of 3,876 men from all those 15,401 workers with at least 3 months' exposure formed the cohort under study. The actual number of person-years of follow-up became 47,160. Total and cause-specific mortality was studied in the entire cohort and in different categories based on exposure time and occupation. The foundry workers' experience was compared to that expected on the basis of the general male population's death rates in Finland, and different categories of the cohort were compared to each other through direct standardization. During the period from 1950 through 1973, there had occurred 224 deaths. The mortality approached the expected value computed from the age-adjusted general male population, the standardized mortality ratio (SMR) being 90 for all foundry workers and 95 for workers in "typical" foundry occupations. The corresponding standard mortality ratios based on the estimated total number of person-years, after the application of corrections for sampling fractions, were 86 and 95, respectively. There was a slight shift of the age of death towards younger age groups among the casters, fettlers, and furnace tenders. Mortality from coronary heart disease showed a standardized mortality ratio of 80 for the whole cohort; no significant differences were found for any occupational category. Lung cancer mortality was higher than expected (SMR 150) in the entire cohort; closer analysis revealed that the excess was confined to iron foundries, and especially to molders with more than 5 years of exposure. There were no more violent deaths than expected, not even from work accidents. Because most occupational cohorts have standardized mortality ratios that are well below 90, the present results were interpreted as probably indicating slightly elevated mortality. The most important finding was the concentration of lung cancer among molders in iron foundries.

摘要

对1950年至1972年期间曾在20家有代表性的铸铁、铸钢和有色金属铸造厂工作过的所有男性工人进行抽样,研究铸造工人的死亡率。从15401名接触时间至少为3个月的工人中抽取3876名男性作为统计样本,构成了研究队列。实际随访的人年数为47160。对整个队列以及根据接触时间和职业划分的不同类别,研究了总死亡率和死因别死亡率。将铸造工人的情况与根据芬兰男性总体死亡率预期的情况进行比较,并通过直接标准化对队列中的不同类别进行相互比较。在1950年至1973年期间,共发生了224例死亡。死亡率接近根据年龄调整后的男性总体计算出的预期值,所有铸造工人的标准化死亡比(SMR)为90,“典型”铸造职业的工人为95。在应用抽样分数校正后,根据估计的总人年数计算的相应标准死亡比分别为86和95。在铸工、清整工和炉前工中,死亡年龄略有向较年轻年龄组偏移的情况。整个队列中心脏病死亡率的标准化死亡比为80;在任何职业类别中均未发现显著差异。整个队列中肺癌死亡率高于预期(SMR为150);进一步分析表明,超额死亡率仅限于铸铁厂,尤其是接触超过5年的造型工。暴力死亡人数并未超过预期,甚至工作事故导致的死亡人数也未超过预期。由于大多数职业队列的标准化死亡比远低于90,因此目前的结果可能表明死亡率略有升高。最重要的发现是铸铁厂造型工中肺癌的聚集现象。

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验