Suppr超能文献

采用聚合物诱导液芯技术对牙本质病损进行功能再矿化。

Functional remineralization of dentin lesions using polymer-induced liquid-precursor process.

机构信息

Department of Preventive and Restorative Dental Sciences, University of California San Francisco, San Francisco, California, United States of America.

出版信息

PLoS One. 2012;7(6):e38852. doi: 10.1371/journal.pone.0038852. Epub 2012 Jun 13.

Abstract

It was hypothesized that applying the polymer-induced liquid-precursor (PILP) system to artificial lesions would result in time-dependent functional remineralization of carious dentin lesions that restores the mechanical properties of demineralized dentin matrix. 140 µm deep artificial caries lesions were remineralized via the PILP process for 7-28 days at 37°C to determine temporal remineralization characteristics. Poly-L-aspartic acid (27 KDa) was used as the polymeric process-directing agent and was added to the remineralization solution at a calcium-to-phosphate ratio of 2.14 (mol/mol). Nanomechanical properties of hydrated artificial lesions had a low reduced elastic modulus (E(R) = 0.2 GPa) region extending about 70 μm into the lesion, with a sloped region to about 140 μm where values reached normal dentin (18-20 GPa). After 7 days specimens recovered mechanical properties in the sloped region by 51% compared to the artificial lesion. Between 7-14 days, recovery of the outer portion of the lesion continued to a level of about 10 GPa with 74% improvement. 28 days of PILP mineralization resulted in 91% improvement of E(R) compared to the artificial lesion. These differences were statistically significant as determined from change-point diagrams. Mineral profiles determined by micro x-ray computed tomography were shallower than those determined by nanoindentation, and showed similar changes over time, but full mineral recovery occurred after 14 days in both the outer and sloped portions of the lesion. Scanning electron microscopy and energy dispersive x-ray analysis showed similar morphologies that were distinct from normal dentin with a clear line of demarcation between the outer and sloped portions of the lesion. Transmission electron microscopy and selected area electron diffraction showed that the starting lesions contained some residual mineral in the outer portions, which exhibited poor crystallinity. During remineralization, intrafibrillar mineral increased and crystallinity improved with intrafibrillar mineral exhibiting the orientation found in normal dentin or bone.

摘要

人们假设将聚合物诱导的液体前体(PILP)系统应用于人工损伤会导致龋齿病变的功能再矿化随时间变化,从而恢复脱矿质牙本质基质的机械性能。通过 PILP 过程,在 37°C 下对 140 µm 深的人工龋损进行再矿化 7-28 天,以确定时间再矿化特征。聚-L-天冬氨酸(27 kDa)用作聚合过程导向剂,并以钙/磷比 2.14(摩尔/摩尔)添加到再矿化溶液中。水合人工病变的纳米力学性能具有低弹性模量降低区(E(R) = 0.2 GPa),延伸约 70 µm 进入病变,斜率区延伸约 140 µm,值达到正常牙本质(18-20 GPa)。与人工病变相比,7 天后标本在斜率区恢复了 51%的机械性能。在 7-14 天之间,病变外部的恢复继续达到约 10 GPa,改善了 74%。PILP 矿化 28 天可使 E(R)相对于人工病变提高 91%。从变化点图确定的这些差异具有统计学意义。通过微 X 射线计算机断层扫描确定的矿物分布比通过纳米压痕确定的矿物分布浅,并且随着时间的推移显示出相似的变化,但在病变的外部和斜率部分都在 14 天后完全恢复了矿物质。扫描电子显微镜和能量色散 X 射线分析显示了与正常牙本质不同的相似形态,病变的外部和斜率部分之间有明显的分界线。透射电子显微镜和选区电子衍射显示,起始病变的外部部分含有一些残余矿物质,其结晶度较差。在再矿化过程中,纤维内矿物质增加,结晶度提高,纤维内矿物质表现出与正常牙本质或骨相似的取向。

https://cdn.ncbi.nlm.nih.gov/pmc/blobs/9ef9/3374775/025cd95955fb/pone.0038852.g007.jpg

文献AI研究员

20分钟写一篇综述,助力文献阅读效率提升50倍。

立即体验

用中文搜PubMed

大模型驱动的PubMed中文搜索引擎

马上搜索

文档翻译

学术文献翻译模型,支持多种主流文档格式。

立即体验