Med Phys. 2013 Jan;40(1):010701. doi: 10.1118/1.4771935.
The feasibility of medical imaging using a medical linear accelerator to generate acoustic waves is investigated. This modality, x-ray acoustic computed tomography (XACT), has the potential to enable deeper tissue penetration in tissue than photoacoustic tomography via laser excitation.
Short pulsed (μs-range) 10 MV x-ray beams with dose-rate of approximately 30 Gy∕min were generated from a medical linear accelerator. The acoustic signals were collected with an ultrasound transducer (500 KHz central frequency) positioned around an object. The transducer, driven by a computer-controlled step motor to scan around the object, detected the resulting acoustic signals in the imaging plane at each scanning position. A pulse preamplifier, with a bandwidth of 20 KHz-2 MHz at -3 dB, and switchable gains of 40 and 60 dB, received the signals from the transducer and delivered the amplified signals to a secondary amplifier. The secondary amplifier had bandwidth of 20 KHz-30 MHz at -3 dB, and a gain range of 10-60 dB. Signals were recorded and averaged 128 times by an oscilloscope. A sampling rate of 100 MHz was used to record 2500 data points at each view angle. One set of data incorporated 200 positions as the receiver moved 360°. The x-ray generated acoustic image was then reconstructed with the filtered back projection algorithm.
The x-ray generated acoustic signals were detected from a lead rod embedded in a chicken breast tissue. The authors found that the acoustic signal was proportional to the x-ray dose deposition, with a correlation of 0.998. The two-dimensional XACT images of the lead rod embedded in chicken breast tissue were found to be in good agreement with the shape of the object.
The first x-ray acoustic computed tomography image is presented. The new modality may be useful for a number of applications, such as providing the location of a fiducial, or monitoring x-ray dose distribution during radiation therapy. Although much work is needed to improve the image quality of XACT and to explore its performance in other irradiation energies, the benefits of this modality, as highlighted in this work, encourage further study.
研究利用医用直线加速器产生声波进行医学成像的可行性。这种模态,即 X 射线声计算机断层扫描(XACT),有可能比激光激发的光声断层扫描实现更深的组织穿透。
从医用直线加速器产生剂量率约为 30Gy/min 的短脉冲(μs 范围)10MV X 射线束。将超声换能器(500KHz 中心频率)放置在物体周围以收集声信号。换能器由计算机控制的步进电机驱动,以在物体周围扫描,在每个扫描位置检测成像平面中的声信号。脉冲前置放大器的带宽为 20kHz-2MHz(-3dB),可切换的增益为 40dB 和 60dB,接收来自换能器的信号,并将放大后的信号传输至二次放大器。二次放大器的带宽为 20kHz-30MHz(-3dB),增益范围为 10-60dB。信号由示波器记录和平均 128 次。在每个视角下使用 100MHz 的采样率记录 2500 个数据点。一组数据包含接收器移动 360°时的 200 个位置。使用滤波反投影算法重建 X 射线产生的声图像。
从嵌入鸡胸组织的铅棒中检测到 X 射线产生的声信号。作者发现声信号与 X 射线剂量沉积成正比,相关系数为 0.998。嵌入鸡胸组织的铅棒的二维 XACT 图像与物体的形状非常吻合。
呈现了第一个 X 射线声计算机断层扫描图像。这种新模态可能在许多应用中有用,例如提供基准的位置,或在放射治疗期间监测 X 射线剂量分布。尽管需要做大量工作来提高 XACT 的图像质量并探索其在其他辐照能量下的性能,但该模态的优势,如本文所述,鼓励进一步研究。