Institute of Chemistry, Center for Nanoscience and Nanotechnology, The Hebrew University of Jerusalem, Jerusalem 91904, Israel.
Institute of Life Science, The Hebrew University of Jerusalem, Jerusalem 91904, Israel.
J Am Chem Soc. 2020 Mar 4;142(9):4223-4234. doi: 10.1021/jacs.9b11847. Epub 2020 Feb 19.
A method to assemble stimuli-responsive nucleic acid-based hydrogel-stabilized microcapsule-in-microcapsule systems is introduced. An inner aqueous compartment stabilized by a stimuli-responsive hydrogel-layer (∼150 nm) provides the inner microcapsule (diameter ∼2.5 μm). The inner microcapsule is separated from an outer aqueous compartment stabilized by an outer stimuli-responsive hydrogel layer (thickness of ∼150 nm) that yields the microcapsule-in-microcapsule system. Different loads, e.g., tetramethyl rhodamine-dextran (TMR-D) and CdSe/ZnS quantum dots (QDs), are loaded in the inner and outer aqueous compartments. The hydrogel layers exist in a higher stiffness state that prevents inter-reservoir or leakage of the loads from the respective aqueous compartments. Subjecting the inner hydrogel layer to Zn-ions and/or the outer hydrogel layer to acidic pH or crown ether leads to the triggered separation of the bridging units associated with the respective hydrogel layers. This results in the hydrogel layers of lower stiffness allowing either the mixing of the loads occupying the two aqueous compartments, the guided release of the load from the outer aqueous compartment, or the release of the loads from the two aqueous compartments. In addition, a pH-responsive microcapsule-in-microcapsule system is loaded with glucose oxidase (GOx) in the inner aqueous compartment and insulin in the outer aqueous compartment. Glucose permeates across the two hydrogel layers resulting in the GOx catalyzed aerobic oxidation of glucose to gluconic acid. The acidification of the microcapsule-in-microcapsule system leads to the triggered unlocking of the outer, pH-responsive hydrogel layer and to the release of insulin. The pH-stimulated release of insulin is controlled by the concentration of glucose. While at normal glucose levels, the release of insulin is practically prohibited, the dose-controlled release of insulin in the entire diabetic range is demonstrated. Also, switchable ON/OFF release of insulin is achieved highlighting an autonomous glucose-responsive microdevice operating as an "artificial pancreas" for the release of insulin.
介绍了一种组装刺激响应型核酸基水凝胶稳定的微胶囊-微胶囊体系的方法。由刺激响应水凝胶层(150nm)稳定的内部水相提供内部微胶囊(直径2.5μm)。内部微胶囊与由外部刺激响应水凝胶层(厚度约为 150nm)稳定的外部水相隔开,形成微胶囊-微胶囊体系。不同的负载物,如四甲基罗丹明-葡聚糖(TMR-D)和 CdSe/ZnS 量子点(QDs),被装载在内、外水相中。水凝胶层处于较高刚性状态,防止负载物从各自的水相之间或从水相中泄漏。将内部水凝胶层暴露于 Zn-离子和/或外部水凝胶层暴露于酸性 pH 值或冠醚,导致与相应水凝胶层相关联的桥联单元的触发分离。这导致水凝胶层的刚性降低,从而允许负载物在两个水相之间混合、从外部水相受控释放负载物,或者从两个水相释放负载物。此外,pH 响应性微胶囊-微胶囊体系在内部水相中装载葡萄糖氧化酶(GOx),在外部水相中装载胰岛素。葡萄糖穿过两层水凝胶渗透,导致 GOx 催化葡萄糖有氧氧化为葡萄糖酸。微胶囊-微胶囊体系的酸化导致外部 pH 响应性水凝胶层的触发解锁和胰岛素的释放。胰岛素的 pH 刺激释放受葡萄糖浓度的控制。在正常葡萄糖水平下,胰岛素的释放实际上被禁止,而在整个糖尿病范围内实现了胰岛素的剂量控制释放。此外,还实现了胰岛素的开关式 ON/OFF 释放,突出了作为胰岛素释放的“人工胰腺”的自主葡萄糖响应微器件。