Jang Jisu, Son Myungwoo, Chung Sunki, Kim Kihyeun, Cho Chunhum, Lee Byoung Hun, Ham Moon-Ho
Center for Emerging Electronic Devices and Systems, Department of Nanobio Materials and Electronics, School of Materials Science and Engineering, Gwangju Institute of Science &Technology, 123 Cheomdangwagi-ro, Buk-gu, Gwangju 61005, Republic of Korea.
Sci Rep. 2015 Dec 10;5:17955. doi: 10.1038/srep17955.
There is significant interest in synthesizing large-area graphene films at low temperatures by chemical vapor deposition (CVD) for nanoelectronic and flexible device applications. However, to date, low-temperature CVD methods have suffered from lower surface coverage because micro-sized graphene flakes are produced. Here, we demonstrate a modified CVD technique for the production of large-area, continuous monolayer graphene films from benzene on Cu at 100-300 °C at ambient pressure. In this method, we extended the graphene growth step in the absence of residual oxidizing species by introducing pumping and purging cycles prior to growth. This led to continuous monolayer graphene films with full surface coverage and excellent quality, which were comparable to those achieved with high-temperature CVD; for example, the surface coverage, transmittance, and carrier mobilities of the graphene grown at 300 °C were 100%, 97.6%, and 1,900-2,500 cm(2) V(-1) s(-1), respectively. In addition, the growth temperature was substantially reduced to as low as 100 °C, which is the lowest temperature reported to date for pristine graphene produced by CVD. Our modified CVD method is expected to allow the direct growth of graphene in device manufacturing processes for practical applications while keeping underlying devices intact.
通过化学气相沉积(CVD)在低温下合成大面积石墨烯薄膜用于纳米电子和柔性器件应用引起了人们的极大兴趣。然而,迄今为止,低温CVD方法由于会产生微米尺寸的石墨烯薄片而导致表面覆盖率较低。在此,我们展示了一种改进的CVD技术,可在常压下于100 - 300 °C的温度范围内,以苯为原料在铜上制备大面积、连续的单层石墨烯薄膜。在该方法中,我们通过在生长前引入抽气和吹扫循环,在不存在残余氧化物种的情况下延长了石墨烯的生长步骤。这使得我们获得了具有全表面覆盖率和优异质量的连续单层石墨烯薄膜,其质量与高温CVD法制备的相当;例如,在300 °C下生长的石墨烯的表面覆盖率、透过率和载流子迁移率分别为100%、97.6%和1900 - 2500 cm² V⁻¹ s⁻¹。此外,生长温度大幅降低至低至100 °C,这是迄今为止报道的通过CVD制备原始石墨烯的最低温度。我们改进的CVD方法有望在实际应用的器件制造过程中直接生长石墨烯,同时保持底层器件完好无损。